FW: [parisc-linux] Finally ... Kernel Booted on C200

[ext-helge.deller@nokia.com]

-----Original Message-----
From: Deller Helge (EXT-NEG/Dusseldorf) 
Sent: Donnerstag, 9. September 1999 9:17
To: 'EXT Ryan Bradetich'
Subject: RE: [parisc-linux] Finally ... Kernel Booted on C200



Yes, but it's really easy with two steps:

1. make vmlinux
2. make Image	(<- Here the ipl will be built & stripped, then ipl and
vmlinux will be added to the file "Image").
3. Boot the file arch/parisc/boot/Image from HDD or via network.


Helge Deller.


> -----Original Message-----
> From: EXT Ryan Bradetich [mailto:rbradetich@uswest.net]
> Sent: Donnerstag, 9. September 1999 5:33
> To: Parisc Linux
> Subject: [parisc-linux] Finally ... Kernel Booted on C200
> 
> 
> Well I'm slowly learning .... :)
> 
> I finally figured out how to compile the cvs tree into a kernel that
> I could boot on the C200.
> These are the steps I followed, will someone verify if they 
> are correct?
> 
> 1. built the kernel using vmlinux,
> 2. built the ipl in arch/parisc/boot/boot_code
> 3. stripped ipl
> 4. mkImage ipl vmlinux vmlinux.boot
> 5 boot off of vmlinux.boot
> 
> At this point I get Tranfering control to kernel.  (At entry point
> 0x00010000)
> The LED are also flashing in some patteren.
> 
> Well, time to start researching signals :)
> 
> -Ryan
> 
> 
> 
> --------------------------------------------------------------
> -------------
> To unsubscribe: send e-mail to 
> parisc-linux-request@thepuffingroup.com with
> `unsubscribe' as the subject.
>