[parisc-linux] Re: kernel-2.4.17-pa22 boot problem B132L+ with serial

[Joël Soete]

Hi Grant,

> Disappointed?! are you kidding?! This is great! :^)

Nice ("disapointing" was just a joke) :-) )

>> ...
>> RAMDISK driver initialized: 16 RAM disks of 6144K size 1024 blocksize
>> loop: loaded (max 8 devices)
>> Linux Tulip driver version 0.9.15-pre9 (Nov 6, 2001)
>> tulip0: no phy info, aborting mtable build
>> tulip0:  MII transceiver #1 config 1000 status 782d advertising 01e1.
>> eth0: Digital DS21143 Tulip rev 65 at 0xf0fff000, 00:10:83:65:09:4B, IRQ
>> 96.

> Is this output from B132L with card-mode Dino?
> or with built-in 21143 on B180L?

It was "built-in 21143 on B180L" (is there a difference here between b180
and b132?)

Joel




                                                                                                                           
                    Grant Grundler                                                                                         
                    <grundler@dsl2.extern        To:     "Joël Soete" <jso@europay.com>                                    
                    al.hp.com>                   cc:     parisc-linux@lists.parisc-linux.org                               
                                                 Subject:     Re: kernel-2.4.17-pa22 boot problem B132L+ with serial       
                    15-02-02 05:48 AM                                                                                      
                                                                                                                           
                                                                                                                           




"=?iso-8859-1?Q?Jo=EBl_Soete?=" wrote:
> Sorry first for delay.
>
> Sorry also if I desapoint you but "CONFIG_TULIP_MMIO=y" works for my b1=
80
> (afaik same HW than b132l+ but processor clock?) with last k-2.4.17-pa23:

Disappointed?! are you kidding?! This is great! :^)

> ...
> RAMDISK driver initialized: 16 RAM disks of 6144K size 1024 blocksize
> loop: loaded (max 8 devices)
> Linux Tulip driver version 0.9.15-pre9 (Nov 6, 2001)
> tulip0: no phy info, aborting mtable build
> tulip0:  MII transceiver #1 config 1000 status 782d advertising 01e1.
> eth0: Digital DS21143 Tulip rev 65 at 0xf0fff000, 00:10:83:65:09:4B, IRQ
> 96.

Is this output from B132L with card-mode Dino?
or with built-in 21143 on B180L?

Just curious....

thanks,
grant






**********************************************************************
This e-mail and any attachments to it may contain confidential information which is strictly intended for the use of the authorised recipient.  If you have received this e-mail in error, please delete it and notify the sender by replying to this e-mail.
Thank you for your co-operation.
**********************************************************************